11/10000 实时翻译 11/10000 Real time Translation Application of WCB Stainless Steel Gear Pump 划译 Application of WCB stainless steel gear pump

WCB stainless steel gear pump belongs to the low-pressure micro portable energy-saving oil transfer pump, which is more suitable for selling unit oil barrels without power supply to convert oil. It is also suitable for oil transfer in refineries, power plants, substations, and oil depots, and for treating thin oil in thin oil lubrication systems. For conveying non lubricating oil, beverages, low corrosive water, etc., please choose an integral stainless steel gear pump.

WCB stainless steel gear pump can transport clean neutral oils with viscosity of 1-8 ° E (such as engine oil, kerosene, diesel and various vegetable oils) from one container to another. It can improve work efficiency and reduce labor intensity, making it suitable for use in industries such as commerce, industry, and agriculture for oil transportation.

Installation of WCB stainless steel gear pump:

1. Before installation, check whether the pump has been damaged during transportation, such as whether the motor has been affected by moisture, whether the dust covers at the inlet and outlet of the pump are damaged, and whether any dirt has entered the pump chamber.

Before installing the pipeline, the inner wall of the pipeline should be cleaned with clean water or steam. It should be avoided that the weight of the pipeline is borne by the pump, which affects the operation and accuracy of the pump.

3. There must be no air or liquid leakage at the connection parts of the pipeline, otherwise liquid cannot be sucked in and noise will be generated.

4. A metal filter should be installed at the suction port to prevent particles, impurities, and other contaminants from entering the pump.

Inspection before starting the pump

1. Are the fasteners of the pump tightened.

2. Whether the active shaft rotates flexibly.

3. Are the valves for the inlet and outlet pipelines open.

4. Whether the rotation direction of the pump meets the requirements (if viewed from the pump end towards the motor, counterclockwise main rotation is considered positive rotation).

Maintenance during pump operation

The pressure of the pump and the reading of the vacuum gauge should comply with the technical specifications specified for the pump.

2. Pay attention to the working condition of the packing seal. If oil leakage occurs, adjust it with a pressure cap depending on the degree (it is not allowed to press the pressure cap too tightly to avoid heating at the packing and wear of the sealing ring).

When there is abnormal noise or high temperature rise during the operation of the pump, the pump should be stopped immediately for inspection.

Stop of pump operation

1. Cut off the power supply.

2. Close the valve of the oil outlet pipeline.