Installation scope and disassembly instructions for Roots oil pump

1、 The installation range of LC Roots pump

The reason why LC Roots pump is loved by many users is that it can be used in many environments and has strong applicability. So the device can be installed both indoors and outdoors, without being affected by environmental conditions. However, it is worth noting that no matter where the device is installed, it should be arranged in the appropriate location as much as possible to ensure good operation of the equipment. For example:

1. Outdoor Layout

Generally, Roots pumps are arranged below or on the side of the pipe gallery, and can also be placed near the suction equipment. The main advantage is good ventilation, easy operation and maintenance. If the pump is arranged below the pipe gallery, the centerline of the pump outlet should be aligned, 0.6m away from the centerline of the pipe gallery column

2. Semi outdoor layout

The LC Roots pump with a semi outdoor layout is suitable for rainy areas. Generally, the pump is installed below the pipe gallery and a ceiling is installed above the pipeline.

. Or arrange the pump on the lower floor of the frame, with the frame platform as the ceiling

3. Indoor Layout

The LC Roots pump installed indoors is suitable for cold or windy sand areas, as well as occasions with process requirements.

Therefore, for different environmental locations, the installation scope and various installation conditions of LC Roots pumps need to be changed accordingly, in order to improve the installation quality. Although this device can be used in many environmental environments, it is still recommended that everyone try not to keep the device exposed to sunlight for a long time, as this can easily cause corrosion of the equipment in the long term

2. Disassembly and Assembly Instructions for Roots Pump

When disassembling Roots pump, pay attention to your own operating behavior, otherwise it is easy to cause damage to the pump body during disassembly and assembly, and even cause the equipment to be unusable. Therefore, below are some instructions and requirements for disassembly and assembly operations to avoid errors during operation.

Before disassembly, measure and record the clearances between each part of the rotor

(2) Try to avoid hitting with a heavy hammer, and the removed parts should not be damaged and kept properly

(3) Record in detail the reasons and usage of the parts that need to be replaced

(4) Before reassembling the Roots pump, all components must be cleaned thoroughly and the brush must be polished

(5) The static sealing surface without sealing gasket or sealing ring should be sealed with silicone paint, and the rubber seal used for static sealing should be coated with vacuum cock grease

(6) Adjust the clearances of each part of the rotor according to the clearance list

After all are installed, a leak detection must be carried out

After reassembly, a trial run and performance test must be conducted, and the Roots pump can only be installed and used after it is functioning properly